To find the parts that fit your machine, click on the link below and select your make, year and model.
Only the products that fit your machine will be shown in the product list
Click Here to Add Your Machine! >>
Features -High-output coils for use in either 2 or 4 cylinder motorcycles -Bikes equipped with capacitive discharge ignition (CDI) -Accel engineers designed these coils' special low resistance primary winding to match the operating characteristics of factory and aftermarket CDI systems -Maximum performance with fast rise times -Extra heavy duty 9mm silicone wires included -Made in the U.S.A. -NOTE: Using wrong coil may damage your motorcycles electronic ignition module. To determine your ignition type complete the following test: -Determine whether the type of coil you are replacing is a high tower coil. (These coils will NOT replace single tower coils) -Using a volt meter or 12V test light, hook the positive lead to the positive post and the negative lead to the ground on one of the stock coils. -Turn the ignition on, but DO NOT engage the starter button -If there are 12V at the coil, the motorcycle has an inductive type ignition. If there is no voltage at the coil, then the motorcycle has a CDI ignition because the power goes to the control box first
(based on 2 reviews)
Reviewed by 2 customers
Displaying reviews 1-2
Back to top
(3 of 3 customers found this review helpful)
from Wellington, KS
Comments about Accel Super CDI Coil Kit:
After reading the recommended procedure to determine if these coils were right for my 1995 Kawasaki GPz 1100. I purchased them. After several hours of modification to fit them on my bike, i started her up and headed down the road. About 15 mins later she died and hasn't run since. Upon later inspection it was determined that the .7 ohm resistance compared to my factory 3 ohm resistance coils caused 15 total amps to rush through my CDI box, DESTROYING IT! Bike Bandit will not refund your money nor help in any other way! I now have a [$] paper weight kit and need a $383 CDI Box. Make sure your primary coil windings are close to the .7 ohm Accel coils or you will be replacing your CDI box.
Bottom Line No, I would not recommend this to a friend
Was this review helpful? Yes / No
- You may also flag this review
(1 of 1 customers found this review helpful)
Great product for an old, tired bike....
from Northumberland, PA
A little tricky to fit on bike, but well worth the time and effort.
Bottom Line Yes, I would recommend this to a friend
Do you have questions about this product?
get answers from real customers and in-house experts with AnswerBox.
Know the answer? Answer this question
Do you have a question about this product?
Specifications and Options