Specifications and Options
(based on 8 reviews)
of respondents would recommend this to a friend.
Reviewed by 8 customers
Displaying reviews 1-4
Back to top
Previous | Next »
from La Grande Or
Comments about Biker's Choice Bullet Turn Signal:
The wire could be longer had to splice. Also the lens is pry off type not screws.
Bottom Line Yes, I would recommend this to a friend
Was this review helpful? Yes / No
- You may also flag this review
Great replacement turn signal!
from Las Vegas, NV
Great replacement turn signal. Looks good and is very functional. A wiring diagram would have made things a little easier, but trial and error was also effective.
works great, fits rebel
By rebel riser
from Katy, TX
See all my reviews
Bought these to replace the OEM ones that were broken on some training rebels I bought. Easily replaced the rear signals with these. Used the shaft hole where the OEM wires went as the hole for the bolt to secure them. Used the bolt hole to run the wires off of the back. The front ones were more complicated on the rebel because I had to build some brackets to hold them as they wouldn't work with the OEM mounts, which were broken anyway. In the end I think they looked pretty good - better than OEM. They did require some soldering so be ready for that. Also, had to buy the securing bolts at the local hardware store. They were not the typical thread pitch for a 5/16 bolt, so had to look amongst the specialty bolts for a finer pitch bolt.
(3 of 3 customers found this review helpful)
Great signal replacement
from Austin, TX
Application: 2002 Honda Rebel, CMX250My OEM turn signal, made of plastic, was broken off by an anonymous neighbor. I purchased 2 of these signal replacements as the 2 of them together was less expensive than the 1 OEM replacement... which is plastic.These signals are all metal and quite durable. The lenses are unblemished and the lights are fairly bright. Very attractive model.The drawback as noted previously is, these do not come with any mounting hardware at all. A quick trip to the local hardware store, I purchased flat washers, lock washers, 2 (1/2") spacers, and 2 (5/8" X 2", 24 thread) mounting bolts.The toughest part was removing the OEM signals and routing the signal wires. The wires on these replacements could've made things a bit easier with another 1/2" of wire to work with, but I was able to install them into the stock relay box without too much hassle.In summary, they look great! Installation time clicked in right under 2 hours. They are very attractive and much more durable than the plastic OEM pieces.
Do you have questions about this product?
get answers from real customers and in-house experts with AnswerBox.
Know the answer? Answer this question
Do you have a question about this product?